An 80 year old model J.C. Higgins Sears Roebuck 22 Single Shot Model 103.18 rifle came back into my life. It was the one that I cut my hunting teeth on as a boy of 11 yrs old. It could shoot 22 Short, 22 Long and 22 Long Rifle ammo and it was very accurate. It was a great woodchuck rifle! Across the street from my home was a 100 acre field full of chucks! I was in boyhood heaven! My father would give be two high velocity 40 grain bullets to shoot at chucks so I had to make them count.

It came back into my life from a relative who had it, but it was in poor condition as the barrel was showing lots of  surface rust. Decades ago the plastic butt plate broke and was replaced with a red rubber boot type that today was found disintegrating. Back in the 1960’s I carved the front of the stock to have a cooler European for-end, but never finished it or stained it. I have recently been re-acquainted with it because of its versatility, shooting shorts, longs and long rifle 22 cartridges.  This little single shot was made for garden pests around the farm besides plinking.  I decided to finish the refurbishment project of long ago and give the rifle a place of honor.

The first thing I did was to point the rifle in a safe direction, open the bolt (it was empty) checked the bore and cleaned it. Safety first! Not as bad as I thought. After cleaning I ran a bit of JB Bore-bright through it. It polished well. I decided to disassemble and inspect it in detail. Again, not as bad as I thought. I sanded the barrel exterior with 400 grit sand paper removing the dovetail sights (with a punch and hammer) and polished the barrel with steel wool for bluing.

I used Birchwood Casey Super Blue. It worked great with 2 coats.

In between bluing, I sanded the stock, replaced and ground and installed a new plastic buttplate.

I stained the rifle stock with some brown gun-stock stain I had on hand from my flintlock build,  and after drying I put 2 light coats of Helmsman Varnish on the rifle stock. I didn’t want it glossy, just enough to protect the finish, after all this is a working rifle.

Now it looks so much better and ready for quietly plinking or garden varmints!

The rear sight was in poor shape and not the original one that was on it. I broke the bank for 14 bucks to put the original dovetail rear sight on it.

I was surprised that there were some parts available for this rifle on-line! Perhaps you may have an old rifle that needs some TLC.

Below is my back yard 25 yard test shot with CCI Quiet-22. It is very quiet and works very well with this rifle. I am a CCI fan! I was only 3/8 inch off with open sights. It’s the first shot that counts!

© 2020 Copyright. All Rights Reserved.

Good Shooting!