Nosler E-Tip and AccuBond Bullet – Best in Class! by Ed Hale

We all enjoy eating our wild game don’t we! I have shot Nosler E-Tips in my game and into media (fir planks) and find that the bullet flairs into petals for the E-Tip and stays together. It is a gilding copper bullet that will leave less copper in your barrel rifling than other bullet manufacturers.

In a deer hunt in 2015, I killed a spike buck at 300 yards with my test gun, a Savage 11/111 in 7mm Remington Magnum’Leupold VX-6 combo, loaded with 140grain Nosler E-Tips. Below is the exit wound.

 

I shot once a bit high and got full penetration, the deer fell like lighting but stood up moments later. The second shot was 4 inches lower through the lower ribs and shoulder and exited. The deer fell in its tracks for good!  No trace of either bullet was found and I liked the fact that there was no chance of lead fragmentation from a bone strike that I have seen in my non bonded cheaper bullets of other manufacture. In bone strikes of early deer kills, I had to cut a large chunk of meat around the bullet path as lead and copper fragments were seen.

AccuBond Bullets are designed where the lead is bonded to the copper and stays together BIGLY, while other bullets come apart.  The AccuBond keeps the lead together much more so, thus I believe it is also best in Class.

The AccuBond has been produced as an “all range” bullet, for near and far. Below is a 800 lb Bison I took with a 260 grain AccuBond with my Ruger M77 African Rifle and VX-3 Leupold Scope at 100 yards quartering away. The bullet entered the last rib and angled forward through the heart and lungs and exited after busting the opposite shoulder. The buffalo dropped in its tracks! No fragments found around the bullet path or wound site.

Another AccuBond Kill was a nice Moose with the same rifle and load.

 

For those who are shooting beyond 500 yards there is the Long Range AccuBond which has one of the highest Ballistic Coefficients for its bonded design as a hunting bullet. See the video below.

I have not had an opportunity to shoot this LRAB as I have no immediate need to hunt that long a range at this time, but if I do, you know I will use this bullet.

In closing, I have had more meat, and less fragment damage with the E-Tip and AccuBond than any hunting bullet EVER!.

UPDATE – My good friend Zach Waterman at Nosler is sending me Nosler gilding copper E-Tips to use on my upcoming Russian Boar Hunt so we can again see how a shoulder hit on a big game animal can still be accomplished with little or no fragmentation and no lead in the meat.

Good Hunting!

© 2017

This entry was posted in Big Game Hunting, Bullet Tests and Reviews. by Ed Hale. Bookmark the permalink.

About Ed Hale

I am an avid hunter with rifle and Bow and have been hunting for more than 50 years. I have taken big game such as whitetail deer, red deer, elk, Moose and African Plains game such as Kudu, Gemsbok, Springbok, Blesbok, and Impala and wrote an ebook entitled African Safari -Rifle and Bow and Arrow on how to prepare for a first safari. Ed is a serious cartridge reloader and ballistics student. He has earned two degrees in science and has written hundreds of outdoor article on hunting with both bow and rifle.

2 thoughts on “Nosler E-Tip and AccuBond Bullet – Best in Class! by Ed Hale

  1. Just picked up some Hornady bullets cheap for the 375 Ruger. I think they are blems or seconds. Should be okay for testing and plinking.

    Could you tell me what you are using for primers ? If I have to use the Large Rifle Magnum primers I will need to find a source. I have plenty of standard LR primers, but not sure if I can use them in reduces loads. The Nyati Inc load article by Ed Hammond does not mention the primers used. I plan to use the Accurate 5744 powder and starting loads from the chart.

    • Hi Tim,
      Standard large rifle primers are just fine. Don’t need magnum for reduced loads. I use CCI the most but also Federal and Winchester.
      The reduced loads should shoot sweet for you. I am just amazed at how accurate the reduced loads can be as well as full power.
      Best,
      Ed

Comments are closed.