Adding a Timney Trigger to my Browning X-Bolt Speed |

Removing the two mounting bolts, you can pop out the barrel and action with some finagling and prying. It is a tight fit.

Here is the Timney Trigger below.

Below there are 2 pins that hold the trigger in the half moon cutouts in the barrel. Use a 1/16 punch to remove the two pins and the trigger will come off.

The part I did not expect is that the Timney did not just drop in. The forward slot was too narrow to fit in the half moon cutout. I had to grind off a few thousandths from the trigger housing to widen the slot with a Dremel tool.

Below you can see my Dremel tool that I used to grind the forward pin housing a bit. Took me 20 minutes to grind and fit it. Not overly hard with the right tool. Some triggers drop in to those slots in videos.

Below is the Timney trigger installed. The whole process took me about an hour or less.

I put my Lyman Trigger test gauge on the Timney and as expected it measured 3 pounds almost. Two pounds fifteen point nine ounces. I tested again at 3 pounds exact. Test the safety slide to be sure it works. Mounting bolts need torque to 35 inch-lbs.

Below is a video that helped me.

Good Shooting.